Assembling
4.3 Notes on installation of SCP / STP transceivers
4.3
Notes on installation of SCP / STP transceivers
General notes on pluggable transceivers
NOTICE
Use only approved pluggable transceivers
If you use components not approved by Siemens AG, in particular SCP / STP transceivers,
Siemens cannot accept any responsibility for the correct functioning of the "Ethernet switch
system" according to the specification.
If components are used that have not been Siemens approved, Siemens cannot vouch for
their compatibility or for risk-free use of these components.
Note
Shipbuilding approval
The shipbuilding approval applies to all SCP / STP transceivers.
Note
Plugging and pulling during operation
The pluggable transceivers can be plugged and pulled during operation. If you have
questions on the use of SIMATIC NET products, please contact your Siemens sales partner.
Notes on SCALANCE XM-400
Note
SCP / STP transceivers can only be used in the SCP / STP slots of the SCALANCE XM408-
4C.
Notes on SCALANCE W:
Note
With a SCALANCE W786-2, do not plug or pull an SFP transceiver during operation!
If you have questions on the use of SIMATIC NET products, please contact your Siemens
sales partner.
18
Transceiver SFP/SFP+/SCP/STP
Operating Instructions, 11/2015, A5E02630804-08