Table of Contents
Advertisement
Assembling
4.4 Notes on installation of SCP / STP transceivers
Follow the steps below to insert a pluggable transceiver:
1. Make sure that the package is complete (Page 15).
2. Check all the parts for transport damage.
3. Remove the plug-in transceiver from its packaging.
4. Make sure that the bracket at the plug-in transceiver is closed.
5. Insert the pluggable transceiver in the pluggable transceiver slot until you hear it engage, see
figure.
The pluggable transceiver is then firmly secured.
6. Remove the sealing plug of the plug-in transceiver.
7. Insert the connecting cable into the pluggable transceiver until you hear it engage.
The connecting cable is then firmly secured.
4.4
Notes on installation of SCP / STP transceivers
General notes on pluggable transceivers
NOTICE
Use only approved pluggable transceivers
If you use components not approved by Siemens AG, in particular SCP / STP transceivers,
Siemens cannot accept any responsibility for the correct functioning of the "Ethernet switch
system" according to the specification.
If components are used that have not been Siemens approved, Siemens cannot vouch for their
compatibility or for risk-free use of these components.
20
WARNING
Do not use any parts that show evidence of damage
If you use damaged parts, there is no guarantee that the device will function according to
the specifications.
If you use damaged parts, this can lead to the following problems:
• Injury to persons
• Loss of approvals
• Violation of the EMC regulations
• Damage to the device and other components
Use only undamaged parts.
Transceiver SFP/SFP+/SCP/STP
Operating Instructions, 10/2023, A5E02630804-18
Advertisement
Table of Contents
