Nokia E60 Connection Manual page 9

WEP key — Enter the WEP key data. The number of
characters you can enter depends on the key length
you have chosen.
Note: Wired equivalent privacy (WEP)
encryption method encrypts data before it
is transmitted. Access to the network is
denied to users who do not have the
required WEP keys. When WEP security
mode is in use, if your device receives a data
packet not encrypted with the WEP keys,
the data is discarded. In an Ad-hoc
network, all devices must use the same
WEP key.
5
After setting up a basic Internet access point for
Wireless LAN, select Back to save the settings and exit,
→
or Options Advanced settings
advanced settings:
•
IPv4 settings — Enter the device IP and name server
addresses for IPv4 Internet protocol.
Modifying EAP settings
The extensible authentication protocol (EAP) plug-ins are
used in wireless networks to authenticate wireless devices
and authentication servers, and the different EAP plug-ins
make possible the use of various EAP methods (network
service).
To use an EAP plug-in when you connect to a WLAN using
the access point, select the desired plug-in and
Enable. The EAP plug-ins enabled for use with this access
to define the following
•
IPv6 settings — Select or enter the name server
addresses for IPv6 Internet protocol.
•
Ad-hoc channel — If the selected network mode is
ad-hoc, select User defined
channel number (1-11).
• Proxy serv. address — Enter the proxy server address.
• Proxy port number — Enter the proxy server port
number. Proxy servers are intermediate servers
between a browsing service and its users, which are
used by some service providers. These servers may
provide additional security and speed up access to
the service.
Note: The settings availabe for editing
may vary. Contact your service provider for
more information.
Copyright © 2006 Nokia. All rights reserved.
to manually enter a
→
Options
9