Nokia E60 Connection Manual page 10

point have a check mark next to them. To not use a plug-
→
in, select Options
To edit the EAP plug-in settings, select
Configure.
To change the priority of the EAP plug-in settings, select
→
Options Raise priority
before other plug-ins when connecting to the network
with the access point, or
this plug-in for network authentication after attempting
to use other plug-ins.
The available options may vary.
Creating an Internet access point
for IP passthrough
→
1
Select Menu
Access points.
10 Copyright © 2006 Nokia. All rights reserved.
Disable.
→
Options
to attempt to use the plug-in
→
Options Lower priority
→ →
Tools Settings Connection
2
The list of existing access points is shown. Select
→
Options New access point
create a new access point.
3
Define the following settings:
• Connection name
Internet access point, such as My IP Passthrough.
• Data bearer
4
After configuring the basic settings for
select Back to save the settings and exit, or
Advanced settings
settings:
•
IPv4 settings
address for the IPv4 Internet protocol.
• IPv6 settings
Internet protocol.
•
Proxy serv. address
server. Proxy servers are intermediate servers
between a browsing service and its users, which are
used by some service providers. These servers may
provide additional security and speed up access to
to use
the service.
• Proxy port number
number.
Note: DNS is an Internet service that
translates domain names such as
www.nokia.com into IPv4 addresses such
as 192.100.124.195, or IPv6 addresses like
3ffe:2650:a640:1c2:341:c39:14.
→
→
Use default settings
— Type a descriptive name for the
— Select IP passthrough.
IP passthrough,
to define the following advanced
— Enter the Phone IP address
— Enter the DNS address for the IPv6
— Enter the address of the proxy
— Enter the proxy server port
to
→
Options
and DNS