Huawei EchoLife EG8143H5 Quick Start Manual page 8

EchoLife EG8143H5
Quick Start for QR code
No.
1
2
3
4
5
6
7
8
9
Issue 01 (2022-11-01)
NO TE
● The fiber connector connected to the optical port on the wall varies depending on
actual conditions.
● To ensure normal use of fibers, make sure that the fiber bending radius is larger than 30
mm.
Item Description
On/Off Powers the ONT on or off.
Power Connects to a power adapter.
TEL Connects to the ports on a telephone or fax machine.
LAN1- Connects to PCs or IP set-top boxes (STBs).
LAN4
CATV Connects to a TV.
WLAN Used to enable or disable the WLAN function.
- When the WLAN is disabled, press the WLAN button (> 3s)
and release the button to enable the WLAN.
- When the WLAN is enabled, press the WLAN button (> 3s)
and release the button to disable the WLAN.
WPS When the WLAN is on, press the WPS button (> 3s) and
release the button to start Wi-Fi protected setup (WPS)
negotiation.
Reset Press the button for a short time to reset the device; or press
the button for a long time (longer than 10s) to restore the
device to the default settings and reset the device.
NOTE
Reset Huawei ONTs with caution. Otherwise, the ONTs may fail to
access the Internet. If an ONT cannot access the Internet after a
reset, contact your Internet service provider.
Optical The optical port is equipped with a rubber plug and
port connected to a fiber for upstream transmission.
The type of the optical connector connected to the optical
port can be SC/APC.
Copyright © Huawei Technologies Co., Ltd.
2 Connecting Cables
5