Maintenance
14.1
Removing and inserting I/O modules
Requirement
Remove or insert front connectors and I/O modules only when the voltage is switched off.
NOTICE
Physical damage can occur
If you install or uninstall front connectors and/or I/O modules with switched-on voltage, this
can lead to undefined conditions in your plant.
The S7-1500 automation system/ET 200MP distributed I/O system may be damaged as a
result.
Therefore only install/uninstall front connectors and/or I/O modules with switched-off
voltage.
Therefore during the planning of a plant always make sure to comply with the necessary,
pertinent standards and safety guidelines.
Replacement part scenario
Replacing the CPU in a replacement part scenario has an impact on the password for
protection of confidential configuration data. When you replace the CPU, observe the rules
for the replacement part scenario in the Communication function manual
(https://support.industry.siemens.com/cs/ww/en/view/59192925).
Automation system
System Manual, 01/2023, A5E03461182-AK
14
299