Table of Contents
Advertisement
2.5.2 Lifting with a crane
A
Bar for lifting (maximum ø 63 mm)
B
Hole to insert the lifting bar
C
Label for holes enabled for lifting
It is recommended to use a system to prevent the belts from slipping from the bars during
lifting.
Place spacers and protectors in between prevent damaging the unit.
• Insert the lifting bars into the arranged holes on the base and indicated by the relative labels.
• Lift the unit using suitable belts.
Make sure that all the equipment used for handling (belts, bars, etc.) are appropriate for
the weight of the unit.
During handling it is prohibited to exceed the maximum inclination allowed, as shown in
the figure.
2.6 Unpacking
A
Wooden support
B
Corner protector
C
Coil protection
• Remove the wooden supports before resting it definitely on the ground.
• Remove the clear film that wraps the machine.
• Remove the corner protectors.
• Remove the coil protectors.
The machine is supplied without shock absorbers. Install any shock absorbers before
resting the machine definitely on the ground.
Only remove the packaging when set in the place of installation.
2.7 Access to internal parts
A
Electrical board door
B
Electrical board panel
C
Side panel
D
Rear panel
• Unscrew the fixing screws and remove the panels.
To access the electrical board:
• Remove the panels of the electrical board.
• Set the disconnecting switch knob to Off.
• Open the doors of the electrical board.
2.8 Resting on the ground
The unit must be positioned on a perfectly horizontal surface that is able to withstand its weight.
Positioning must be performed slowly and so that all support points are touching the floor.
9
Advertisement
Table of Contents
