Ricoh Ri 1000 Parts Replacement page 170

Ri 1000 Replace Power Supply Unit
Introduction
This TD&R document is intended to aid RICOH Ri 1000 users in providing maintenance
and basic repair service. The information provided is intended to help with performing a
Power Supply Unit replacement. Accordingly this TD&R document is limited to meet the
objectives indicated above.
The majority of the hardware used in the RICOH Ri 1000 Direct to Garment printer is in
Metric series.
When performing maintenance on the machine, be sure to wear commercially available
goggles, gloves and a mask.
Scope
This applies to RICOH Ri 1000 printers.
Symptoms/ When To Replace
1. The machine will not power up
2. The machine powers up but CTL USB error appears and con not be cleared
3. Can not read 24V with volt meter at the sub control board
4. There is no movement in the X axis motor and the maintenance unit motor
Supplies
Required supplies:
1. Power Supply Unit (J1025003)
2. #1 Phillips Head Screwdriver
170