Preface
Introduction
The EasyLAN Network Setup is a PC confi guration wizard that
facilitates the connection of an EasyCoder printer to a wired or wireless
network. In simple terms, what you can do is this:
• Connect a printer to the PC via a serial communication channel.
• Start the wizard.
• Select or fi nd out which type of fi rmware the printer is using
(Fingerprint or IPL).
• Establish the communication (port, baud rate, data bits, stop bits, and
parity).
• Log in.
• Set up parameters for wireless communication.
• Set up the printer's IP parameters (applies to both Ethernet and
wireless communication).
• Review the settings.
• Upload the settings to the printer and, optionally, save the
confi guration on a CompactFlash memory card inserted in the
printer.
Supported Platforms
The EasyLAN Network Setup wizard supports these platforms:
• Microsoft Windows 2003 Server
• Microsoft Windows XP
• Microsoft Windows 2000
• Microsoft Windows NT 4
• Microsoft Windows Me
• Microsoft Windows 98
Microsoft Internet Explorer 5.01 (or higher) is required
Printer Firmware and Hardware
The printer must either be running Intermec Fingerprint v8.10 (or later)
or IPL v2.10 (or later). An EasyLAN Ethernet or EasyLAN Wireless
interface must be installed.
iv
Intermec EasyLAN Network Setup—User's Guide