Your Scooter - I-GO S20 Owner's Manual

TILLER CONSOLE
The tiller console houses all controls needed to drive your scooter, including the battery condition meter and
throttle. See fi gure 1.
PROHIBITED! Do not expose the tiller console to moisture. In the event that the tiller console
does become exposed to moisture, do not attempt to operate your scooter until the tiller console
has dried thoroughly.
Figure 1. Tiller Console
NOTE: Before initial use, the battery must be activated. For activation instructions, see III "Batteries and
Charging"/IV "Operation."
Key Switch
 Insert the key into the key switch and turn it clockwise to power up (turn on) your scooter.
 Turn the key counterclockwise to power down (turn off ) your scooter.
Throttle Control Lever
This lever allows you to control the forward speed and the reverse speed of your scooter.
To use throttle control lever:
 To move Forward, use your right thumb to push the right side of the throttle control lever.
 To move Rearward, use your left thumb to push the left side of the throttle control lever.
Lights Switch
This switch controls your scooter's lighting system.
 Toggle the switch forward to turn on the lighting system.
 Toggle the switch rearward to turn off the lighting system.
i-Go™
I I . Y O U R S C O O T E R
IDENTIFICATION KEY
1. Mirror and Mirror Plug
2. HI-Low Switch
3. Battery Condition Meter
4. Horn
5. Key Switch
6. Throttle
7. USB Charger
8. Light Switch
7