I-GO S20 Owner's Manual page 23

V I I . C A R E A N D M A I N T E N A N C E
ELECTRONICS
(Joystick controller, enhanced displays, touch screens, remote controls, keyboards, cell
phones and tablets, as applicable)
 For electronics, remove visible contamination if present.
● Turn off product and disconnect batteries.
● Never spray any liquids directly into the product(s).
● Moisten a microfi ber cloth with a mixture of 70% isopropyl alcohol/30% water solution. The cloth should
be damp, but not dripping or excessively wet. Dry surfaces thoroughly to avoid pooling of liquids and
prior to boxing.
WARNING! Follow all safety instructions for the proper use of the disinfectant and/or cleaning
agent before applying it to your product. Failure to comply may result in skin irritation or
premature deterioration of upholstery and/or scooter fi nishes.
WARNING! Never use any cleaning or disinfecting agent, solvent, lubricant, or any other product
on the brake pads, brake discs, transaxle, motor/gearbox of your mobility product. Doing so
may damage the components and/or cause them not to function properly. Property injury and/
or personal injury may result.
WARNING! Never hose off your scooter or place it in direct contact with water. Your scooter has a
plastic body shroud that allows it to be easily wiped clean with a damp cloth.
WARNING! Never use any chemicals to clean a vinyl seat, as they may cause the seat to become
slippery or dry out and crack. Use soapy water and dry the seat thoroughly.
BATTERY PACK CONNECTIONS
Make certain that the battery pack terminal connectors are tight and not corroded.
WIRING LEADS
 Regularly check all wiring connections.
 Regularly check all wiring insulation, including the charger power cord, for wear or damage.
 Have your authorized Dealer repair or replace any damaged connector, connection, or insulation that you fi nd
before using your scooter again.
PROHIBITED! Even though the scooter has passed the necessary testing requirements for
ingress of liquids, you should keep electrical connections away from sources of dampness,
including direct exposure to water or bodily fl uids and incontinence. Check electrical components
frequently for signs of corrosion and replace as necessary.
WARNING! Do not pull on electrical cords directly to detach them from the scooter. Always
grasp the connector itself when disconnecting the cords to prevent wire damage.
DAILY CHECKS
 With the power turned off , check the throttle. Make sure it is not bent or damaged and that it returns to the
neutral position when you release it. Do not try to repair it. See your authorized Dealer if there is a problem.
 Visually inspect all of the cables in the tiller. Make sure none are frayed, cut or have any wires exposed. See
your authorized Dealer if there is a problem.
 Check for fl at spots on tires. Flat spots could adversely aff ect stability.
 Check the brakes. This test should be carried out on a level surface with at least 3 feet (1 meter) of clearance
around your scooter
 Check all cables, wires, latches and levers daily.
 Check the brake handles and wires daily. Contact your authorizd Dealer if there is a problem.
i-Go™
23