Mazda 2 HYBRID Owner's Manual page 337

336
6-3. Do-it-yourself maintenance
NOTICE
When replacing tire valve caps, do
not use tire valve caps other than
those specified. The cap may
become stuck.
To avoid damage to the tire pres-
sure warning valves and trans-
mitters
When a tire is repaired with liquid
sealants, the tire pressure warning
valve and transmitter may not operate
properly. If a liquid sealant is used,
contact any authorized Mazda retailer
or Mazda authorized repairer, or any
reliable repairer as soon as possible.
Make sure to replace the tire pressure
warning valve and transmitter when
replacing the tire. (→P.335)
Initializing the tire pressure
warning system
The tire pressure warning sys-
tem must be initialized in the
following circumstances:
When rotating front and rear tires
which have different tire inflation
pressures.
When changing the tire size.
When the tire inflation pressure
is changed such as when chang-
ing traveling speed or load
weight.
When changing between two
registered wheel sets.
When the tire pressure warning
system is initialized, the current tire
inflation pressure is set as the
benchmark pressure.
How to initialize the tire pres-
sure warning system
1
Park the vehicle in a safe place
and turn the power switch off,
wait for approximately 15 min-
utes or more, and then perform
the procedure.
2
Adjust the tire inflation pressure
to the specified cold tire inflation
pressure level. (→P.426)
Make sure to adjust the tire pressure to
the specified cold tire inflation pressure
level. The tire pressure warning system
will operate based on this pressure
level.
3
Turn the power switch to ON.
Initialization cannot be performed while
the vehicle is moving.
4
Press /
or / (horizontal display)
of the meter control switch to
select .
5
Press /
or / (horizontal display)
to select "Vehicle Settings" and
then press and hold
6
Press /
setting" and then press
7
Press /
Pressure". Then press and hold
until the tire pressure warn-
ing light blinks 3 times.
Then a message will be displayed on
the multi-information display. "--" will be
displayed on the multi-information dis-
(vertical display)
(vertical display)
.
to select "TPWS
.
to select "Setting