Related Manuals for DEVAISE AHDG036
Summary of Contents for DEVAISE AHDG036
-
Page 3: General Guidelines
IMPORTANT INFORMATION READ CAREFULLY. KEEP THIS INFORMATION FOR FURTHER REFERENCE. GENERAL GUIDELINES • • Please read the following instruction carefully and use the product accordingly. • Please keep this manual and hand it over when you transfer the product. This summary may not include every detail of all variations and considered steps. Please contact us when further information and help are needed. - Page 5 If you have any further questions, please feel free to contact us by email or official website: devaise-cs@devaise.com We will reply ASAP. Before installation, please make sure you have all the hardware, the serial numbers are properly labeled corresponging to the list, and the quantity is correct.
-
Page 6: Exploded Drawing
EXPLODED DRAWING... - Page 7 PARTS M4x10 REMARK...
- Page 8 Press the plastic part in the indicated direction to separate drawer runner before assembling. Please grip the part while sliding the part. PRESS MINIFIX POSITION...
- Page 9 DEV ISE REMARK Put a blanket under the board to avoid scratch or damage. Please do not screw too deep or too shallow. ×4 ×8...
- Page 10 M4x10 BOTTOM REMARK When installing, please make sure the screws are flattened, not crooked; Otherwise the drawers will not be installed perfectly. FRONT...
- Page 11 M4x10 BOTTOM REMARK When installing, please make sure the screws are flattened, not crooked; Otherwise the drawers will not be installed perfectly. 1. Please locate the holes from the back of part 2. Then please install part from the front of part E1 Back FRONT E1 Front...
- Page 12 ×4...
- Page 13 M4x10 ×16...
- Page 14 ×2 ×2...
- Page 15 ×2 ×2...
- Page 16 M4x10 ×2 FRONT FRONT FRONT...
- Page 17 M4x10...
- Page 18 FRONT FRONT...
- Page 19 ( 1 ) ( 2 ) Letter Size As shown in Fig. (1) installation method, the A4 Size file can be hung after installation. As shown in Fig. (2) installation method, the Letter Size file can be hung after installation.
- Page 20 M4x10 FRONT FRONT FRONT...
- Page 21 FRONT FRONT FRONT BALL BEARING REMARK BALL BEARING FRONT Please full extend the slide runners. 2. Simply push the ball bearing cart all the way to the end of the slide(in both sides). 3. It is recommended to install the bottom drawer first to prevent tipping.
Need help?
Do you have a question about the AHDG036 and is the answer not in the manual?
Questions and answers