Advertisement
Quick Links
Advertisement
Related Manuals for DEVAISE AHDG018
Summary of Contents for DEVAISE AHDG018
- Page 1 DEV ISE AHDG018 Wood Large 1 Drawer Mobile Cabinet V2.1 www.devaise.com...
- Page 2 DEV ISE IMPORTANT INFORMATION READ CAREFULLY. KEEP THIS INFORMATION FOR FURTHER REFERENCE. GENERAL GUIDELINES • • Please read the following instruction carefully and use the product accordingly. • Please keep this manual and hand it over when you transfer the product. This summary may not include every detail of all variations and considered steps.
- Page 3 DEV ISE If you have any further questions, please feel free to contact us by email or official website: www.devaise.com We will reply ASAP. Before installation, please make sure you have all the hardware, the serial numbers are properly labeled corresponging to the list, and the quantity is correct.
- Page 4 DEV ISE EXPLODED DRAWING:...
- Page 5 DEV ISE PARTS: M4x14 M4x10 REMARK: 1. Press the plastic part in the indicated direction to separate drawer runner before assembling. 2. Please grip the part while sliding the part. PRESS...
- Page 6 DEV ISE REMARK: MINIFIX POSITION REMARK: Please do not screw too deep or too shallow. Appropriate position Too deep Too shallow ×8 ×4...
- Page 7 DEV ISE REMARK: When installing, please make sure the screws are flattened, Not crooked; Otherwise the drawers will not be installed M4x14 perfectly. REMARK: 1. Please locate the holes from the back of part FRONT E1 Back: E1 Front: 2. Then please install part from the front of part...
- Page 8 DEV ISE ×4 REMARK: Let the grooves on part 2 and 3 be connected to the groove on part 4 .
- Page 9 DEV ISE...
- Page 10 DEV ISE REMARK: Let the grooves on part 1 2 and 3 be connected to the groove on part 7 .
- Page 11 DEV ISE 10 /...
- Page 12 DEV ISE M4x14 M4x14 11 /...
- Page 13 DEV ISE M4x14 12 /...
- Page 14 DEV ISE 13 /...
- Page 15 DEV ISE 14 /...
- Page 16 DEV ISE M4x14 15 /...
- Page 17 DEV ISE M4x10 16 /...
- Page 18 DEV ISE BALL BEARING REMARK: 1.Please full extend the slide runners. 2.Simply push the ball bearing cart all the way to the end of the slide(in both sides). REMARK： 1. Align the slide runners on the drawer with the unit and push it carefully inside until it stops.
- Page 19 DEV ISE ×8 REMARK: Please put the board into the cabinet tiltly as shown. REMARK: Please make the groove on board 10 and 11 match with the part 18 /...
- Page 20 DEV ISE M4x14 ×8 19 /...
- Page 21 DEV ISE HINGE ADJUSTMENT If the door do not appear square or aligned, loosen or tighten the appropriate screws on each case hinge as illustrated. Depth adjustment Loosen screw and screw ( Do not loose screw to the end), push hinge arm forwards or backwards, re-tighten screw Side to side adjustment Adjust gap with screw...
Need help?
Do you have a question about the AHDG018 and is the answer not in the manual?
Questions and answers