Related Manuals for DEVAISE AHDG028
Summary of Contents for DEVAISE AHDG028
-
Page 2: General Guidelines
IMPORTANT INFORMATION READ CAREFULLY. KEEP THIS INFORMATION FOR FURTHER REFERENCE. GENERAL GUIDELINES • • Please read the following instruction carefully and use the product accordingly. • Please keep this manual and hand it over when you transfer the product. This summary may not include every detail of all variations and considered steps. NOTES •... - Page 3 Before installation, please make sure you have all the hardware, the serial numbers are properly labeled corresponging to the list, and the quantity is correct. Enjoy your new purchase!
-
Page 4: Exploded Drawing
EXPLODED DRAWING... - Page 5 PARTS M4x14...
- Page 6 REMARK Press the plastic part in the indicated direction to separate drawer runner before assem- bling. Please grip the part while sliding the part. PRESS MINIFIX POSITION...
- Page 7 REMARK Please do not screw too deep or too shallow. DEV ISE Appropriate position Too deep Too shallow Put a blanket under the board to avoid scratch ×6 or damage. ×4...
- Page 8 M4x14 ×8 BOTTOM REMARK When installing, please make sure the screws are flat- tened, Not crooked; Otherwise the drawers will not be installed perfectly. FRONT...
- Page 9 M4x14 BOTTOM REMARK 1. Please locate the holes from the back of part 2. Then please install part from the front of part E1 Back FRONT E1 Front FRONT...
- Page 10 ×6 REMARK Let the grooves on part be connected 、 to the groove on part...
- Page 12 M4x14 ×2 ×2 ×4...
- Page 13 ×2...
- Page 14 ×2...
- Page 16 M4x14 FRONT FRONT FRONT...
- Page 17 M4x14 FRONT FRONT FRONT...
- Page 18 ( 1 ) ( 2 ) Letter Size As shown in Fig. (1) installation method, the A4 Size file can be hung after installation. As shown in Fig. (2) installation method, the Letter Size file can be hung after installation.
- Page 19 M4x14 FRONT FRONT FRONT...
- Page 20 FRONT FRONT FRONT REMARK BALL BEARING BALL BEARING FRONT Please full extend the slide runners. 2. Simply push the ball bearing cart all the way to the end of the slide(in both sides).
- Page 21 REMARK Align the slide runners on the drawer with the unit and push it carefully inside until it stops. If the drawer does not go in smoothly please take it out and repeat the step. ×4 ×4...
- Page 22 FRONT long short REMARK The long shadow part is in front and the short one is inside. REMARK Please make the groove on board match with the part ×16 ×16...
- Page 23 M4x14 ×4 ×4...
- Page 24 M4x14 ×8...
Need help?
Do you have a question about the AHDG028 and is the answer not in the manual?
Questions and answers