Advertisement
Quick Links
Advertisement
Related Manuals for DEVAISE ADYJ002
Summary of Contents for DEVAISE ADYJ002
-
Page 2: General Guidelines
IMPORTANT INFORMATION READ CAREFULLY. KEEP THIS INFORMATION FOR FURTHER REFERENCE. GENERAL GUIDELINES • • Please read the following instruction carefully and use the product accordingly. • Please keep this manual and hand it over when you transfer the product. This summary may not include every detail of all variations and considered steps. Please contact us when further information and help are needed. - Page 3 If you have any further questions, please feel free to contact us by email or official website: devaise-cs@devaise.com We will reply ASAP. Before installation, please make sure you have all the hardware, the serial numbers are properly labeled corresponging to the list, and the quantity is correct.
-
Page 4: Exploded Drawing
EXPLODED DRAWING PARTS M4x11 M4x14... - Page 5 REMARK MINIFIX POSITION DEV ISE REMARK 1. Please do not screw too deep or too shallow. 2. Put a blanket under the board to avoid scratch or damage. ×2 ×4...
- Page 6 REMARK The innerside should be the edge banding side. REMARK The position indicated by the finger on the side without eccentric hole is correct .
- Page 7 ×2...
- Page 8 DOWN REMARK The down should be the edge banding side. DOWN REMARK Please make sure the up side slot of part is on the same side.
- Page 9 REMARK Let the grooves on part be connected to the groove on part...
- Page 11 M4x11 M4x11 M4x14 ×16 ×8...
- Page 12 long short REMARK 1. The long shadow part is in front and the short one is inside. 2. Part is adjustable shelf . 3. Please make the groove on part match with the part M4x14 M4x11 M4x14...
- Page 13 M4x11 M4x11 M4x14 ×12...
- Page 14 M4x14 ×4...
-
Page 15: Hinge Adjustment
HINGE ADJUSTMENT If the door do not appear square or aligned,loosen or tighten the appropriate screws on each case hinge as illustrated. DEPTH ADJUSTMENT Loosen screw ( Do not loose screw to the end), push hinge arm forwards or backwards, re-tighten screw SIDE TO SIDE ADJUSTMENT Adjust screw...
Need help?
Do you have a question about the ADYJ002 and is the answer not in the manual?
Questions and answers