Advertisement
Quick Links
Advertisement
Related Manuals for DEVAISE ASNG010
Summary of Contents for DEVAISE ASNG010
-
Page 2: General Guidelines
IMPORTANT INFORMATION READ CAREFULLY. KEEP THIS INFORMATION FOR FURTHER REFERENCE. GENERAL GUIDELINES • • Please read the following instruction carefully and use the product accordingly. • Please keep this manual and hand it over when you transfer the product. This summary may not include every detail of all variations and considered steps. Please contact us when further information and help are needed. - Page 3 If you have any further questions, please feel free to contact us by email or official website: www.devaise.com We will reply ASAP. Before installation, please make sure you have all the hardware, the serial numbers are properly labeled corresponging to the list, and the quantity is correct.
-
Page 4: Exploded Drawing
EXPLODED DRAWING... - Page 5 PARTS M4x14 REMARK...
- Page 6 MINIFIX POSITION DEV ISE REMARK Put a blanket under the board to avoid scratch or damage. ×8...
- Page 7 M4x14 BOTTOM REMARK When installing, please make sure the screws are flattened, Not crooked; Otherwise the drawers will not be installed perfectly. Please do not install the bottom drawer runner part in this step, Otherwise it will not be able to install the connector housing ( Part C ), the bottom step 7 drawer runner part will be installed in FRONT...
- Page 8 REMARK Please do not screw too deep or too shallow. ×12...
- Page 9 REMARK Please make the screw holes on part and part are relative when installing. REMARK 2 3 4 Let the grooves on part be connected to the groove on part ×6...
- Page 10 M4x14 FRONT...
- Page 11 M4x14 ×16...
- Page 12 ×5 ×5...
- Page 13 ×5 ×5...
- Page 14 ×5...
- Page 15 M4x14 FRONT FRONT FRONT ×5...
- Page 16 ×2 ×5 M4x14...
- Page 17 M4x14...
- Page 18 ×4 REMARK Please make the groove on board match with the part...
- Page 20 M4x14 ×8...
-
Page 21: Hinge Adjustment
HINGE ADJUSTMENT If the door do not appear square or aligned,loosen or tighten the appropriate screws on each case hinge as illustrated. DEPTH ADJUSTMENT Loosen screw ( Do not loose screw to the end), push hinge arm forwards or backwards, re-tighten screw SIDE TO SIDE ADJUSTMENT Adjust screw...
Need help?
Do you have a question about the ASNG010 and is the answer not in the manual?
Questions and answers