Minimum Clearance To Combustible Materials - Regency Classic F1150 Manual

Please read the section below carefully as clearances depend on whether single wall or double wall pipe is installed on the stove.
Measurements "From Unit" are from the top plate of the stove to a side wall or to a corner, and from the rear heat shield to a back wall.
Clearances may only be reduced by means approved by the regulatory authority.
Note: Minimum ceiling height - 83" (2108mm)
Note: This clearance is also required for air space between the appliance and wall/ceiling.
ROOF EXIT
F
WALL EXIT
Residential Installation "C" Vent (Single Wall Pipe)
F1150 with Airmate or
Rear Deflector
Residential Close Clearance (To be installed with required pipe components) Listed Double Wall Pipe
When the stove is installed as a close clearance residential unit, a listed double wall connector is required from the stove collar to the ceiling
level.
F1150 with Airmate or
Rear Deflector
Mobile Home Close Clearance (To be installed with required pipe components) Listed
Double Wall Pipe
When the stove is installed as a close clearance residential unit, a listed double wall connector is required from the stove collar to the ceiling
level.
Refer to Mobile Home Installation in this manual.
F1150 with Airmate or
Rear Deflector
2 | F1150 Wood Stove

MINIMUM CLEARANCE TO COMBUSTIBLE MATERIALS

C
A
D
A B
13" 10-1/2"
330mm 267mm
A B
11" 7"
279mm 178mm
A B
11" 7"
279mm 178mm
NOTE: Be aware that local Codes and
ROOF EXIT
WALL EXIT
C D
9" 25"
229mm 635mm
C D
5" 23"
127mm 584mm
C D
5" 23"
127mm 584mm
Regulations may override some
clearances listed in this manual.
Check with your local inspector.
NOTE: Clearances to combustibles are for
the safety of the property. To avoid
overheating and damaging the
appliance these clearances should
be maintained for non-combustibles
also.
E
17-1/16"
433mm
E
13-9/16"
345mm
E
13-9/16"
345mm
F
21"
532mm
F
17"
432mm
F
17"
432mm