Advertisement
CONTROL PANEL BASIC FUNCTION SETTINGS
1
Coding transmitters
Press and hold on "Code" button for 1 second until the LED
dot is on (Fig A). Press button on transmitter once, the dot will go off,
press the same transmitter button again and the dot will flash fast for 8
times and then return to standby mode.
The transmitter is now coded into the receiver.
Repeat the above steps to code more transmitters.
The receiver has the capacity to store 20 transmitters.
If the LED display flashes "F" and returns to standby mode
(after you have pressed the "CODE" button), this indicates that the
memory storage is full (20 transmitters).
Follow the steps below to delete all transmitters that are stored in the
receiver memory.
Press and hold on "CODE" button for more than 8 seconds until the LED
flashes "C", all the stored codes are deleted. Only the matched switch on
the transmitter is available.
If failed to match the transmitter within 20 seconds, then
it will return to standby mode automatically.
The opener is supplied with pre-coded transmitters.
2
Travel limit setting opening & closing force self-learning
Press and hold on "SET" button for 3 seconds until the
LED flashes "1".
Press "SET" button again for 1 second "1" should now display as steady
(not flashing)
Then adjust the up limit by pressing "UP" button.
Fine tuning "UP" or "DOWN" button to determine the final up limit
position (the LED flashes "n" or "u" during opening or closing), then
press "SET" button the display turn into "2"
Adjust the down limit by pressing "DOWN" button.
Fine tuning "UP" or "DOWN" button to determine the final
position (the LED flashes "n" or "u" during opening or closing), then
press "SET" button.
When button is pressed to operate the opener, if the opener stops after
operating a little and LED flashes "H" or "C" this indicates there's no hall
signal or the opener is overloaded.
The opener will operate a cycle automatically to remember the limit
positions and the original opening & closing force before returning to
standby mode.
During learning, if the door stops unusually and flashes "H","C", "O", "L"
for 5 seconds this indicates there's no hall signal overload, overtime,
wrong limit has been set.
automatically.
down limit
3
Advertisement
