Summary of Contents for PDS CW-509
- Page 1 Owners Operating Manual Counterweight Garage Door Automatic Operator Model CW-509 PDS Garage Doors & Gates 38 Yale Drive Epping (Vic) 3076 Phone: (03) 9408 3418 Email: service@pdsgaragedoors.com.au Web: www.pdsgaragedoors.com.au...
- Page 2 Control Panel Basic Function Settings 1. Matching the receiver and transmitter Coding Transmitters: Press and hold on “Code” button for 1 second until the LED dot is on (Fig A). Press button on transmitter once, the dot will go off, press the same transmitter button again and the dot will flash fast for 8 times and then return to standby mode.
- Page 3 3. Safety reverse force adjustment. Press and hold “SET” button for 3 seconds until the LED flashes “1” Press “UP” or “DOWN” button until LED flashes “2” then press “SET” button. It’s now under force adjustment mode. The LED displays the current set force. Press “UP”...
- Page 4 Power Failure – Manual Release Procedure Step 1. Locate the manual release rod. Locate the yellow ring handle manual release turn rod which is positioned between the two steel ramp rails. Ramp rails are located on the same side of the motor and are attached to the back of the door panel.
- Page 5 Continue to turn the release rod clockwise until the steel bearing on the release rod is located between the steel ramp plates. PDS Garage Doors & Gates 38 Yale Drive Epping (Vic) 3076 Phone: (03) 9408 3418 Email: service@pdsgaragedoors.com.au...