FEATURES OF PDS3000 Motor features: 2 remotes 1 wall mountable remote Light on control box Manual release bolt Auto reverse function Auto force sensing Option for Safety Sensors Option for keypad 4 button remote (can add receiver to gate or other doors)
CONTROL PANEL BASIC FUNCTION SETTINGS Coding transmitters Press and hold on “Code” button for 1 second until the LED dot is on (Fig A). Press button on transmitter once, the dot will go off, press the same transmitter button again and the dot will flash fast for 8 times and then return to standby mode.
Page 4
Safety reverse force adjustment Press and hold “SET” button for 3 seconds until the LED flashes “1” Press “UP” or “DOWN” button until LED flashes “2” then press “SET” button. It’s now under force adjustment mode. The LED displays the current set force.
Page 5
POWER FAILURE - MANUAL RELEASE PROCEDURE Locate the manual release rod. Step 1 Locate the yellow ring handle manual release turn rod which is positioned between the two steel ramp rails. Ramp rails are located on the same side of the motor and are attached to the back of the door panel.
We recommend that your garage door is serviced annually to ensure that your attached opener can operate optimally and to allow us to inspect the system for any potential problems that may be occurring. PDS Garage Doors 38 Yale Drive...