Advertisement
3
Safety reverse force adjustment
Press and hold "SET" button for 3 seconds until the LED flashes "1"
Press "UP" or "DOWN" button until LED flashes "2" then press "SET"
button.
It's now under force adjustment mode. The LED displays the current set
force.
Press "UP" button to increase the force and "DOWN" button to decrease
the force.
The maximum force is 9 and the minimum is 1.
Press "SET" button to confirm, the opener will return to standby mode.
The default setting of safety force is 5.
4
Photo beam setting
Press and hold on "SET" button for 3 seconds until the LED flashes "1"
Press "UP" or "DOWN" button until the LED flashes "3", press "SET"
button, it's now under photo beam setting mode. The LED displays the
current setting.
Press "UP" button, the LED displays "1", the photo beam function is
available. Press "DOWN" button the LED displays "O" to cancel this
function. Press "SET" button to confirm. The opener returns to standby
mode.
The default setting of photo beam is "O".
!
The photo beam function
should remain
when photo beam sensor
installed/in use
IMPORTANT
IMPORTANT
photo beam function should
remain deactivated
deactivated when
beam sensors are not
s are not
use. .
4
Advertisement
