System Bring-Up; Configuring Network Attributes Using Nvidia Onyx (Mlnx-Os) - Nvidia Spectrum-3 SN4000 Series Hardware User Manual

• ATTENTION Risque de choc et de danger e'lectriques. Le de'branchment d'une seule
alimentation stabilise'e ne de'branch uniquement qu'un module "Alimentation
Stabilise'e". Pour isoler completement le module en cause, Il faut de'brancher
toutes les alimentations stabilise'es.

System Bring-Up

For bring-up of a switch system with NVIDIA Onyx (MLNX-OS) operating system installed,
see Configuring Network Attributes Using NVIDIA Onyx
For bring-up of a switch system with Cumulus Linux operating system installed,
Network Attributes Using Cumulus

Configuring Network Attributes Using NVIDIA Onyx (MLNX-OS)

The procedures described in this chapter assume that you have already installed and powered on
the system according to the instructions in this document. The system comes with a pre-configured
DHCP. If you wish to disable it, refer to
a manual configuration is required, please refer to the instructions in
Manual Host Configuration
To perform initial configuration of the system:
Step 1. Connect a host PC to the Console RJ45 (
harness cable (DB9 to RJ45). Make sure to connect to the Console RJ45 port and not to the
(Ethernet) MGT (
Step 2. Configure a serial terminal program (for example, HyperTerminal, minicom, or Tera Term) on
your host PC with the settings described in the table below. Once you perform that, you should get
the CLI prompt of the system.
Serial Terminal Program Configuration
Baud Rate
Data bits
Stop bits
Parity
Flow Control
Step 3. Login as admin and use admin as password. On the first login, the NVIDIA Onyx (MLNX-OS)
configuration wizard will start.
Linux.
Disable Dynamic Host Configuration Protocol
) port.
Parameter
(MLNX-OS).
Manual Host
) port of the system, using the supplied
115200
8
1
None
None
see Configuring
(DHCP). In case
Configuration.
Setting
38