Bison VB6000 Assembly And Safe Use Manual

—— Assembly and safe use Manual ——
VB6000, VB6050
Match Point Volleyball Systems
P A R T S L I S T
Item Qty Description
A 1 VB60 Winch Standard
B 1 VB60 Non-Winch Standard
C 2 Floor Sockets (if applicable)
D 1 VB1250KU Net
Inspect all contents prior to installation. Report any missing parts to dealer immediately.
¨
Read all instructions before proceeding.
¨
These systems can be adjusted from 7'11-5/8" men's net height to 42" tennis height.
¨
1. If applicable, follow the instructions provided with the Floor Sockets (C) to prepare the court for system
installation, use the diagram on page 3 to locate the Floor Sockets (C) on your court.
2. Place the VB60 Standards (A) and (B) in the Floor Sockets (C) with the Slider Bars toward the inside of
the court. See Figure 4.
3. Uncoil approximately 24" of the web strap from the winch to allow for net tensioning.
4. Remove the VB1250KU Net (D) from the box
and tie an overhand knot on one end of the top
rope creating a loop. Note: There may be a
factory tied knot already on your net.
5. Attach the loop in #4 above to the hook on the top
of the VB60 Non-Winch Standard (B).
See Figure 1
6. Slide the net along the top rope until the end of
the net is 1' to 2' from the VB60 Non-Winch
Standard (B). The top rope will have excess
length on the opposite end to allow for wider
location of the floor sockets. Don't cut off any
excess top rope at this point. See Figure 1
Implementation Date: 2/16/23 N.J.C Rev: 4
Item Qty Description
E 1 VB13 Net Antennas (Pair, if applicable)
F 2 VB51P Post Padding (if Applicable)
G 4 Rope Ratchet Tensioners (Packaged with Net)
H 2 Height Labels (Packaged with Standards)
FIGURE 1
File: \96\VB60.pub
1
Customer Service
(800) 247-7668
Ref#: 960444 L.M.