Table of Contents
Advertisement
16. Electrical Safety and Standard
16.1. Guidance and Manufacturer's Declaration – Electromagnetic Immunity
The transmitter is intended for use in an electromagnetic environment as specified in Table 8.
The customer or the user of the transmitter should make sure that it is used in such an
environment.
It is possible that certain wireless Wi-Fi routers, Wi-Fi boosters, and Bluetooth devices (such as
mobile phones, wireless audio devices, or computers) may interfere with the Base Station
wireless communications. If you experience delays in Base Station communications, try moving
either the Base Station or the other wireless device(s) away from each other.
16.2. Electromagnetic Immunity Specifications
This test applies only to output lines intended to connect directly to outdoor cables.
SIP/SOPS that have a maximum cable length less than (10 feet) long are excluded.
Testing may be performed at other modulation frequencies identified by the Risk
Management Process.
Calibration for current injection clamps shall be performed in a 150.
Connectors shall be tested per 8.3.2 and Table 4 of IEC 61000-4-2:2008. For
insulated connector shells, perform air discharge testing to the connector shell and
Page | 31
Table 8. Electromagnetic Immunity Specifications
Instructions for Use
Rev. 4
CanarE System
Advertisement
Table of Contents
