Table of Contents
Advertisement
Mode Value
Mode Value
1
Station mode
2
SoftAP mode (factory default)
3
Station+SoftAP mode
#2. Enable DHCP
AT Command: AT+CWDHCP_CUR Syntax:
Type Command
Query AT+CWDHCP_CUR?
Set
AT+CWMODE_CUR=<para>,<en> OK
Defined values:
Parameter Value
0
DIsable SoftAP DHCP & Station DHCP.
1
Enable SoftAP DHCP & Disable Station DHCP.
2
Disable SoftAP DHCP & enable Station DHCP.
3
Enable SoftAP DHCP & Station DHCP. (factory default)
#3. List available APs
AT Command: AT+CWLAP Syntax:
Type Command
Response
Query AT+CWLAP +CWLAP:([<ecn>,<ssid>,<rssi>,<mac>,<channel>,<wps>])
Defined values:
Parameter Value
0: Open
1: WEP
<ecn>
2: WPA_PSK
3: WPA2_PSK
4:WPA_WPA2_PSK
<ssid>
string parameter. AP ssid
<rssi>
signal strength
<mac>
string parameter. AP mac
0: Disable WPS
<wps>
1: Enable WPS
#4. Connect to AP
AT Command: AT+CWJAP_CUR Syntax:
Type Command
Set
AT+CWJAP_CUR=<ssid>,<pwd>,[<bssid>]
Defined values:
Parameter Value
<ssid>
string parameter. Target AP의 ssid. MAX: 32 bytes
<pwd>
string parameter. Target AP의 password. MAX: 64-byte ASCII
<bssid>
string parameter, target AP' MAC address, used in case if there are several APs with same SSID.
#5. Azure IoT Hub configuration set
AT Command: AT+AZSET
Syntax:
Type Command
Set
AT+AZSET=<iothub_name>,<device_id>,<device_key> OK
Defined values:
Parameter Value
Response
+CWDHCP_CUR:<para>
OK
Response
+CWJAP_CUR:<ssid>,<bssid>,<channel>,<rssi>
OK
Response
Advertisement
Table of Contents
