Wiznet WizFi360-CON Getting Started page 130

Connect to Azure IoT Hub using WizFi360 MQTT AT Command
#Getting started
Login to Azure Portal.
※ In this guide we will procedd with
[MS] Create IoT Hub using Azure Portal
Create Blob storage using Azure Portal
Create Stream Analytics using Azure Portal
Setup Queries in Stream Analytics using Azure Portal
Connect to Azure IoT Hub using WizFi360 MQTT AT Command
#Introduction
It is possible to connect to Microsoft Azure Service using WizFi360, send data to cloud and monitor current status.
Data communication will be established as following.
MQTT AT Commands will be used to connect to IoT Hub Service & send data.
Data sent to IoT Hub will be saved in Blob Storage through Stream Analytics.
In this guide we will use WizFi360 with
#Step 1: Required items
Items below are required for this guide.
#Hadrware
Desktop or Laptop Computer
WizFi360-EVB-Shield
Arduino Mega 2560
USB Type-B Cable
#Software
Arduino IDE
Preferred Serial Terminal (TeraTerm, Hercules, etc . . .)
#Step 2: Device preparation
#1. Hardware preparation
WizFi360-EVB-Shield will be installed on top of Arduino Mega 2560. Therefore DIP Switch and jumper cables shall be connected as following:
SW1 : Off
SW2 : Off
SW3 : On
WizFi360-EVB-Shield : D8 - Arduino Mega 2560 : 18
WizFi360-EVB-Shield : D2 - Arduino Mega 2560 : 19
WizFi360-EVB-Shield : SDA - Arduino Mega 2560 : 14
free account. To learn how to create IoT Hub please refer to
Arduino to connect to Microsoft Azure Services using MQTT AT Command.
Azure Cloud Service Introduction.