Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for BLACK NOISE SALLEN KEY
Summary of Contents for BLACK NOISE SALLEN KEY
- Page 2 BLACK NOISE warrants the contents of this kit to be free of defects in materials or workmanship and the trimmer. If you have to be conform with the specifications at the time of shipment for a period of two years from the date received a trimmer with a of purchase.
- Page 3 SALLEN-KEY SALLEN-KEY Build instructions Build instructions Clean the PCB Place the LEDs Cut off the trimmer tabs and clean flux Place the LEDs as shown in the picture residue around the pin-header and but not solder them yet. trimmer with isopropyl alcohol. The shortest leg of the LED is the cathode (-).
- Page 4 SALLEN-KEY SALLEN-KEY Build instructions Build instructions Place the jack connectors Solder the components Install the jack connectors. Turn over your module and solder the Before placing the jacks make sure that components starting with jack sockets, none of the legs of the sockets are bent the potentiometers, the capacitors and then place the them.
- Page 5 SALLEN-KEY SALLEN-KEY Build instructions Build instructions Check your module Place the knobs Set your multimeter to "continuity", You can now place and screw the connect one of the probe to one the the potentiometers on the potentiometers as ground pin. Test +12V and -12V pins with shown in the picture.
Need help?
Do you have a question about the SALLEN KEY and is the answer not in the manual?
Questions and answers