Download
Share
Print this page
BLACK NOISE SAM-C Build Instructions
  1. Manuals
  2. Brands
  3. BLACK NOISE Manuals
  4. Recording Equipment
  5. SAM-C
  6. Build instructions

BLACK NOISE SAM-C Build Instructions

Hide thumbs
1
2
3
4
5
6

Advertisement

Quick Links

Download this manual

Advertisement

loading
Need help?

Need help?

Do you have a question about the SAM-C and is the answer not in the manual?

Questions and answers

Related Manuals for BLACK NOISE SAM-C

Summary of Contents for BLACK NOISE SAM-C

  • Page 2: Contents Of Kit

    To configure your module as a crossfader, make sure the A jumpers-pads are soldered, the B is SAM-C, a small module that takes up no space in your rack and can perform many jumpers-pads must not be soldered. simple but useful utility functions.
  • Page 3 SAM-C SAM-C Build instructions Build instructions Install the 10K resistors Install the potentiometer Place the 10K resistors R1, R2 and R5 as Install the potentiometer, do not solder it shown in the picture. Do not solder the yet. resistors yet.
  • Page 4 SAM-C SAM-C Build instructions Build instructions Install the faceplate Install the jack sockets nuts The faceplate has two sides, on one side Place the nuts of the jack sockets and it says SAM below the potentiometer, on screw them. the other side it says Crossfader. Place the faceplate for which indicates the selected mode.
  • Page 5 Clean the PCB Test your SAM-C Clean the PCB of flux and solder residue You can now test your SAM-C. To learn using Isopropyl alcohol. more about the different modes you can consult the manual using the QR code below.