ABB i-bus® KNX PARAMETERS
Parameter
• Parameter setting
• Move to position
• Enable group objects "Move to pos. height/Move to pos. slat"
• Determine slat adjustment time
• Number of slat adjustments (from 0 % = open to 100 % = closed)
• Limit step commands to number of slat adjustments
• Total turning of slats after downward movement
• Slat position after reaching lower end position (100 % = disabled)
• Limit travel range via group object
• Set dead times
• Tensioning of the blind/shutter / slot positioning
7.9.4.1
Parameter setting
This parameter can be used to define whether the settings for the parameter window are adopted from
the template or each parameter is set individually.
Options
Apply from template
Individual
• Duration of slat adjustment (step)
• Total duration for slat turning from 0 % - 100 %
• Upper limit (0 % = top; 100 % = bottom)
• Lower limit (0 % = top; 100 % = bottom)
• Upper limit valid for automatic sun protection commands
• Upper limit valid for direct commands
• Lower limit valid for automatic sun protection commands
• Lower limit valid for direct commands
• Dead time blind/shutter from bottom until moving up
• Dead time of slat from 100 % closed until slat turn
• Slippage of slat on change of direction
• Slippage of blind/shutter on change of direction
• Duration for tensioning
The parameterization is adopted from the template for each parameter.
Parameters can be set individually.
•
Move to position
•
Enable group objects "Move to pos. height/Move to pos. slat"
•
Determine slat adjustment time
•
Number of slat adjustments (from 0 % = open to 100 % = closed)
•
Limit step commands to number of slat adjustments
•
Total turning of slats after downward movement
•
Slat position after reaching lower end position (100 % = disabled)
•
Limit travel range via group object
•
Set dead times
•
Tensioning of the blind/shutter / slot positioning
Product manual | SAH/S x.x.7.1 | 2CDC505173D0211 Rev. A 146