The Mode Button; Taking Still Photos - NanoCamPlus NCP-DVRGWS User Manual

• At first, the Dash Camera functions will be unresponsive and will take a moment to start
recording. Please note, when your vehicle is off, the Dash Camera will also stop recording.
• Because of how some vehicles are wired, recording may continue when the engine is off.
You can remove the power adaptor or manually turn off the Dash Camera to avoid this.
9.1

THE MODE BUTTON:

The Mode Button is on the right-hand side of the Dash Camera and is marked with an "M".
• The Mode Button is used to switch the Dash Camera function from Video to Camera
mode, which can take still photos.

10.0 TAKING STILL PHOTOS

To take still Photos with the Dash Camera, you will need to stop recording and adjust the mode
settings by following these steps:
• Press the OK Button to press 'stop the Dash Camera recording'.
• Press the Mode Button located on the RIGHT side of the Dash Camera to enable the photo
function.
• To take a photo, press the OK Button.
• To revert to Video recording mode, press the Mode Button again.
NOTE: The Dash Camera must be connected to power to take still photos.
15