Table of Contents
Advertisement
•
When compete, press the MENU button to return to the main options.
16.9
G-SENSOR
The G Sensor defines the required force needed to trigger an Emergency Recording. Once
triggered, the current recording will be saved and protected from being saved over by
normal Loop Recording.
To set the required sensitivity please follow the instructions below:
•
Highlight the G-Sensor option and press OK to open this setting.
•
A screen listing the G-Sensor options will present. Use the Up or Down arrow to choose
either OFF, High, Middle or Low.
•
Highlight to select your preference and press OK to confirm.
•
When compete, press the Menu button to return to the main options.
16.10 MOTION DETECTION
Motion Detection monitors on screen movement and will start recording when movement is
detected. Motion Detection will also stop recording after 10 seconds of no on screen movement.
To carry out this task please follow these steps:
•
Highlight to select the Motion Detection function and press OK to confirm.
•
A screen listing the Motion Detection options of ON or OFF will present. Use the Up or
Down arrow to choose. Highlight to select your preference and press OK to confirm.
•
When compete, press the Menu button to return to the main options.
31
Advertisement
Table of Contents
