General Set-Up Commands; A - Auto-Send Reading - GE Baker Hughes 8000 Series Instruction Manual

Chapter 4. Programming Guide

4.6 General Set-up Commands

4.6.1 A - Auto-send Reading

This command sets the interval between each transmission. The interval can be to one
decimal place, i.e., 1.5 seconds. Entering a negative number causes an error.
Note: Setting this interval to less than the measurement interval (Q Command), causes
the output of the same reading twice or more.
Command:
where: <Interval> is a number between 0.1 and 9999. This is the interval in seconds
Reply:
Reply:
Result:
Command:
where: <Interval> is a number between 0.1 and 9999. This is the interval in seconds
Reply:
Reply:
Result:
Query:
Reply:
Query:
Reply:
18 | 8000/8100/8200 Series Instruction Manual-English
<SPACE>A,<Interval><CR>
between successive transmissions.
None in network mode.
In direct mode:
<Pressure reading><CR>
A pressure reading is transmitted every <Interval> seconds in the
format set in the set-up commands. The interval input is non-volatile.
<SPACE>*A,<Interval><CR>
between successive transmissions.
None in network mode.
In direct mode:
<Pressure reading><Units><CR>
A pressure reading and the units of pressure measurement is
transmitted every <Interval> seconds in the format set in the set-up
commands. The interval input is non-volatile.
<SPACE>A,?<CR>
<Transmission interval set>,<Y if Units displayed, N if units not
displayed><CR>
<SPACE>*A,?<CR>
Interval = <Transmission interval set><CR>
Units = <Yes if Units displayed, No if units not displayed><CR>
© 2010 Baker Hughes, a GE company – All rights reserved.