P - Change Pin - GE Baker Hughes 8000 Series Instruction Manual

Chapter 4. Programming Guide
Command:
Reply:
Reply:
Reply:
Reply:
Reply:
Reply:
Reply:
Reply:
Reply:
Result:

4.7.5 P - Change PIN

This command sets the PIN of the transducer that must be used to access the PIN protected
settings. To change this setting the current PIN must be used and can be integers between 0
and 999.
Command:
where: <Current PIN> is the PIN of the transducer.
<New PIN>
Reply:
Result:
26 | 8000/8100/8200 Series Instruction Manual-English
<SPACE>*O<CR>
(Interactive)
Enter PIN => (enter PIN)
0 - 19200 bps.<CR>
2 - 4800 bps.<CR>
4 - 1200 bps.<CR>
6 - 300 bps.<CR>
Select Baud rate (0 - 6) => (enter selection)
Enter parity ([N]one/[I]gnore/[E]ven/[O]dd) => (Enter parity)
Enter number of data bits (7/8) => (Enter number of data bits)
Enter number of stop bits (1/2) => (Enter number of stop bits)
Software Handshaking? (Y/N) => (Enter Y or N)
Number of termination characters (1 = CR, 2 = CRLF) => (Enter number
of termination characters)
Accept these values? (Y/N) => (Enter Y or N)
(Y answered) "EEPROM updated"<CR>
(N answered) "Current settings left unchanged"<CR>
These settings take effect after switching off then on the power supply
for the transducer.
<SPACE>P, <Current PIN>,<New PIN><CR>
is the replacement PIN.
n/a
The PIN of the transducer changes to new PIN.
1 - 9600 bps.<CR>
3 - 2400 bps.<CR>
5 - 600 bps.<CR>
© 2010 Baker Hughes, a GE company – All rights reserved.