Introduction; General; Configuration; Figure 1 External And Internal Dps 5000 Sensors - General View - GE DPS 5000 Series User Manual

1

Introduction

1.1

General

The DPS 5000 series sensor is a microcontroller based smart pressure transducer
that provides a digital output through an I
as either an external or internal variant. The external variant is a sealed device with
the electrical connections made via an integral cable. The internal variant is an
open frame device with electrical connections made via an integral plug.
Figure 1
The DPS 5000 series sensors are low powered devices offering a high level of
accuracy over a wide temperature range.
compensated pressure and temperature readings and allows the sensor operation
to be software controlled.
1.2

Configuration

The following options are available at the time of ordering:
a) External or internal sensor variant
b) Pressure range
c) Pressure connector
Each sensor is supplied with the following documentation:
d) Hazardous area installation instructions
Document K0546 for the external sensor variant
Document K0547 for the internal sensor variant
e) Calibration certificate
2
Only supplied with hazardous area certified sensors
K0582 Revision B
C-bus interface. The sensor is available
2
External and internal DPS 5000 sensors – General view
May 2015
The I C-bus interface provides
2
2 :
1