Measuring Pressure; Factory Defaults - GE Baker Hughes 8000 Series Instruction Manual

The maximum USB cable length is 9 ft 10 in (3 metres). The transducer can be connected to a
PC, or to a mobile device.
Drivers are available for the following operating systems:
• Android™
• Linux®
• Microsoft Windows®

3.6 Measuring Pressure

The frequency output from the sensor is counted for a fixed number of cycles by the
microprocessor. Measurement cycles are continuous, each cycle delivers new values of
frequency and temperature. See Section 4.4 on page 15 for instructions on how to read a
pressure measurement from the transducer.

3.7 Factory Defaults

Transducers are shipped with the following factory defaults (unless alternatives have been
requested):
© 2010 Baker Hughes, a GE company – All rights reserved.
Table 3-1: Factory Defaults
Parameter
Units
a
PIN
Address
Long error messages
Communications Set-up
Update rate
Filter
User message
Measurement speed
Mode
a. PIN functions are disabled in USB versions. The
default PIN value is not applicable for USB versions.
Value
mbar, displayed as text
after reading.
000 (not set)
Direct mode
Present
9600, 8, N, 1
1 reading/second
Disabled
None
300 ms to 560 ms
Direct
8000/8100/8200 Series Instruction Manual-English | 11
Measuring Pressure