Removing The Cover Plate For Power Supply Box, Fb Print And Cpu - Wittenborg FB 7100 Service Manual

Service Manual FB 7100
K.2.3 Removing the cover plate
for power supply box, FB print and CPU
Preparation
Removal
Step
1
2
3
Installation
January, 2005
Before removing the cover plate for power supply box:
• Disconnect the power supply.
• Open the door.
• Remove the freshbrewer unit, see chap. 5.B.3.2, page 5B-4.
Ensure that the machine is disconnected from the mains electrical supply!
The machine is only isolated from the mains supply when the plug has
been pulled out.
Follow these steps to remove the mounting plate for power supply box:
Action
Loosen three screws on
mounting plate.
Pull forward to release the two
hooks at the top of the
machine.
Remove electrical connection
from print board, and lift out
cover plate.
Installation is done in reverse order.
Illustration
5K - 3