Manitou R7 EXPERT Service Manual page 15

DAMPER SERVICE
Remove rebound damper assembly
8
from the fork. Once the damper
assembly is removed, clean
the inside of the stanchion with
isopropyl alcohol and a lint free
towel. Inspect the inside and
outside of the stanchion for
scratches and other damage.
Inspect rebound damper for
damage and replace if necessary.
Install rebound damper assembly
9
into stanchion. Rotating clockwise,
start the end cap threads by hand
to prevent cross-threading.
*PRO MODEL* Use a 26mm crow's
foot, Manitou slotted cassette tool,
and torque wrench to tighten to
60-80 in lbs [6.8-9.0 N m].
*EXPERT MODEL* Use a 22mm
crow's foot and torque wrench to
tighten to 80-100 in lbs [9.0-11.3
N m].
15
R7 EXPERT / PRO SERVICE GUIDE