Completing The Settings - Mitsubishi Electric PAR-SL101A-E Series Operation Manual And Installation Manual

6. Function settings
D
J
0
4
Fig. 6-3
4) Louver setting (The factory setting is "01".)
1. Press the
• The louver G blinks.
2. Press the
number D.
Louver setting G
No display (Disabled)
G
• To enable (02) the louver function, disable (01)
H
the horizontal airflow direction function.
* If the setting is incorrect, press the
ton 6 and repeat the procedure from step 1.
5) Auto fan speed and airflow direction setting (The
factory setting is "02".)
1. Press the
• The auto fan speed and airflow direction H
9
2. Press the
1
number D.
Auto fan speed and airfl ow
3
6
* If the setting is incorrect, press the
ton 6 and repeat the procedure from step 1.
6) Set temperature range setting (The factory setting
is"01".)
1. Press the
• The number for the set temperature range
2. Press the
number D.
Set temperature
range setting J
(Standard)
Notes:
• If the setting is incorrect, press the
ton 6 and repeat the procedure from step 1.
• Single set point (Auto mode) must be selected
to enable the setting "04". Refer to 7.3. for the
unit function selection and 5.4. for the way to
change the mode by the remote controller.
• The set temperature range of "04" cannot be
selected if the model does not support it.
6.4. Completing the settings (Fig. 6-3)
Press the
• The remote controller exits the function setting
mode.
button 9.
button 4 to select the setting
Setting No.D
01
(Enabled) 02
button 0.
blink. (2 locations)
button 4 to select the setting
direction setting H
No display (Disabled)
(Enabled)
button 1
setting J "01" blinks.
button 4 to change the setting
Cooling/Dry: 19 - 30 °C (67 - 87 °F)
Heating: 17 - 28 °C (63 - 83 °F)
Auto: 19 - 28 °C (67 - 83 °F)
Cooling/Dry: 14 - 30 °C (57 - 87 °F)
Heating: 17 - 28 °C (63 - 83 °F)
Auto: 17 - 28 °C (63 - 83 °F)
button 3 for 5 seconds.
but-
en
Setting No. D
01
02
but-
Setting
number D
01
04
but-
9