Sublink - ADTRAN ATLAS User Manual

Chapter 4. Defining Packet Endpoints
S
UBLINK
4-20
Write Security: 3; Read Security: 5
Displays test menus for the packet endpoint sublinks. The menus vary
depending on the protocol. Testing is not supported on TBOP or PPP.
N
AME
User-defined name for the DLCI.
DLCI
Local address for each PVC as assigned by the carrier.
T
EST
Shows the test mode for this PVC.
S
TART
The fixed duration that T
ured for continuous in-band delay measurement. To change this option,
set D M
IAGNOSTIC ODE
Delay Measurement on page 4-17).
C D
ONT LY
The fixed duration T
continuous in-band delay measurement. The following R
accumulates these measurements.
S T
TOP ST
The fixed duration T
shows the time remaining in the current test.
D
URATION
Shows the duration in seconds for the fixed-duration test.
R [MN/AV/MX D
ESULTS
Displays the minimum, average, and maximum delay for the delay-mea-
surement test.To display the additional test results, place the cursor over
this field and press
Enter
E P T
CHO KT X
Displays the total number of test packets that have been transmitted.
E P R
CHO KT X
Displays the total number of test packets that have been received.
E P D
CHO KT ROPPED
Displays the total number of packets lost in the receiving direction
(traveling from the remote ADTRAN frame relay device to the ATLAS).
R P D
MT KT ROPPED
Displays the total number of packets lost in the transmit direction (trav-
eling from the ATLAS to the remote ADTRAN frame relay device).
M D
IN ELAY
Displays the minimum round trip delay for the current test period.
M D
AX ELAY
Displays the maximum round trip delay for the current test period.
A D
VG ELAY
Displays the average round trip delay for the current test.
ATLAS Frame Relay User Manual
is not running and the DLCI is not config-
EST
to I - D M
N BAND ELAY EASUREMENT
is not running and the DLCI is configured for
EST
is running. The following D
EST
]
LY
on the keyboard. These times are in milliseconds.
(also see In-Band
menu
ESULTS
field
URATION
61200263L1-1.1