Dell UP2720QA Simplified Service Manual page 18

8
9
10
1. Insert USB BD wire to TBT BD
2. Assemble Rear Cover with
Middle Frame
3. Lock 4 screws on Rear Cover
4. Lock 2 screws on the bottom side
of Rear Cover
To attach the monitor stand:
1. Follow the instructions on the
flaps of carton to remove the
stand from the top cushion that
secures it
2. Insert the stand base blocks fully
into the stand slot
3. Lift the screw handle and turn the
screw clockwise
4. After tightening the screw, fold
the screw handle flat within the
recess
Attach the stand assembly to the
monitor.
a. Fit the two tabs on the upper part
of the stand to the groove on the
back of the monitor
b. Press the stand down till it snaps
into place
- 18 -
Philips-
head
screwdriver
Torsion of
Rear Cover
screw:
9±1kg
Torsion of
Bottom side
of Rear
Cover
screw
4.5±0.5kg