Figure 2.2 Attach Drawer Slides To Frame Rails - ILX Lightwave LDM-4616 User Manual

R A C K M O U N T I N G I N S T R U C T I O N S
2
C H A P T E R
Attach the drawer slides to the fram rails using four of the 8-32 x 3/8" pan head
Phillips screws and 8-32 hex nuts. Make sure the correct holes are lined up.
See Figure 2.2 You may need to push on the drawer slide latch to release the
sliding mechanism.

Figure 2.2 Attach Drawer Slides to Frame Rails

If you want to secure your LDM-4616 mount shut in the rack so it does not slide
open, install the two 10-32 speed nuts to the front vertical columns of the rack.
Mounting location would be in the same horizontal plane as the drawer/frame
slides. This allows the LDM-4616 to be secured shut in the rack with the two 10/32
x 1/2" ornamental screws when desired.
Next, mount the slide assemblies to the vertical columns of the rack using four of
the 8-32 x 3/8" pan head Phillips screws and 8/32 hex nuts. The slide mechanism
will have to be moved back and forth until you see the mounting hole in the frame
rail through the large hold in the drawer slide. See Figure 2.3.
Carefully insert the pullout members on the LDM-4616 into the drawer slides
within the rack. Note the initial insertion into the rack will seem tight. Smooth easy
travel should resume after initial insertion.
6
 LDM-4616