Table of Contents
Advertisement
Configuring the IBM WAN Adapters
Before you can use the IBM WAN Adapters, you must
configure it to work with your communications software.
The documentation which came with this software
contains complete instructions on how to configure the
card. During configuration, note the following:
• The ports are numbered Port 1 and Port 2 as indicated
in the diagram to the right (IBM PCI WAN MultiPort
T1/E1 S94 and IBM PCI WAN MultiPort T1/E1 P92
only).
• One or both LEDs flash when the card is being con-
figured. This feature is useful when more than one
card is installed in the same PC.
• Consult the documentation which came with your net-
working software for more information about the
LEDs.
Configuring the IBM WAN Adapters
6
LED 1
Port 1
LED 2
Port 2
Figure 3: End Bracket
Advertisement
Table of Contents
