Table of Contents
Advertisement
20. Plumb the optional regulator overflow to the
inlet side of the pump as follows:
A. Remove the hose that runs from the
regulator to the tee fitting (Fig. 11).
B. Remove the tee fitting and the two hoses
between the spray wash nozzles (Fig. 11).
Figure 11
1. Hoses (between nozzles
and tee fitting)
2. Tee Fitting
1
2
3
3. Hose (from regulator to
tee fitting)
C. Install new blue 3/8" (9.5 mm) hose
between the spray wash nozzles (Fig. 12).
D. Install new blue 3/8" (9.5 mm) hose to the
regulator. Route the hose around the
left-hand side of the machine, then through
the machine frame to behind the engine
(Fig. 12).
1
Figure 12
1. Regulator
2. Blue 3/8" (9.5 mm) Hose
(from Regulator to tee
fitting behind engine)
Installation
2
3
3. Blue 3/8" (9.5 mm) Hose
(between spray wash
nozzles)
11
Advertisement
Table of Contents
