Myfi Settings- Mode, Quality And Auto Scan; To Adjust Shuffle; To Adjust Repeat - Neuros Digital Audio Computer 128MB User Manual

The default MyFi setting is Auto Detect. In this mode, your Neuros will turn off MyFi when
earphones are plugged in and will turn on when no earphones are plugged in. With no
earphones attached, selecting Play will start MyFi for broadcast through an FM radio.
To adjust MyFi Quality:
interference than does Stereo. If you are using the Neuros in congested areas
and are having trouble with interference, try using the Mono setting.
To initiate Auto Scan
(See Using MyFi, above).
NOTE: Earphones must be plugged in (they act as the Neuros FM tuner antenna) for Auto
Scan to work properly
To learn how to broadcast your music through any FM radio, see "MyFi" in the Table of
Contents.

To adjust Shuffle

From the Settings menu, select Shuffle
Select from Sequential (songs played in the order in which they are listed on the Neuros) or
Random.

To adjust Repeat

From the Settings menu, select Repeat
Select from Off (no repeat), Repeat One (repeats same song continuously), Repeat All
(repeats entire track list, artist, album or playlist continuously).
1. From the Settings menu, select Auto-off
2. Select from Off, after 5 minutes, after 10 minutes, after
15 minutes, after 30 minutes, after 60 minutes. Left click
to save your selection.

MyFi settings- Mode, Quality and Auto Scan

To change MyFi Mode:
1. From the Settings menu, select MyFi, then select Mode.
2. Select either Off or Auto Detect
1. From the MyFi Settings menu, select MyFi Quality, then
select Quality.
2. Select either Mono or Stereo. The default setting for MyFi
is Mono. You can change this setting to Stereo.
3. Adjust MyFi Gain (optional). You can increase the gain on
your MyFi broadcast through the MyFi entry in Settings, or
by right-clicking and selecting MyFi Gain during track
playback and right-clicking.
NOTE: Mono broadcasting has better resistance to
19