Neuros Digital Audio Computer 128MB User Manual page 14

2. From the MyFi menu, select Auto Scan. The Neuros will scan over 70 frequencies, so
this can take a few minutes. Auto Scan is complete when the blinking eye animation
stops and the frequency selected remains on the screen. Unplug your earphones.
3. Tune the radio that you would like to use for your broadcast to the frequency that
Neuros Auto Scan has returned to you. (NOTE: If Auto Scan chooses an FM
frequency already containing a broadcast signal, you may want to manually adjust
the FM frequency. See the To manually adjust the MyFi transmission frequency
section that follows).
4. Return to the Neuros Audio menu and select the music for your broadcast.
5. Click Play. MyFi Playback will begin.
6. Control the volume using your FM radio as you normally would. The volume control
buttons on the Neuros are not operational while MyFi is being used.
NOTE: You can Auto Scan at any time. The identified frequency will be stored on your
Neuros and is visible from the "Now Playing" screen when you click Play with the earphones
unattached.
To manually adjust the MyFi transmission frequency
1. Unplug the earphones from the Neuros.
2. Manually select an open FM frequency on the radio you want to use for your
broadcast.
3. Begin playing a song or recording. Click Up or Down on the Neuros' Joystick button
to set the Neuros to the same frequency as the frequency chosen in Step 2.
The Neuros factory default setting for MyFi is Auto Detect. This means that when Neuros
detects earphones, MyFi will not be available. Unplug your earphones when you want to use
MyFi to broadcast through any FM radio.
Through MyFi on the Settings menu, you can change the setting to have MyFi always off.
You can also choose the MyFi Quality- Mono or Stereo.
To adjust MyFi Gain
Through MyFi on the Settings menu, you can now adjust the MyFi gain (FM broadcast
volume) before using MyFi by selecting Gain and using the Joystick to increase or decrease
gain.
During track playback, you can adjust the MyFi gain by right-clicking on the Joystick and
selecting the MyFi Gain Xi menu.
To switch from MyFi to earphones (5 ways)
1. Right click on the Joystick and select Stop. Plug in earphones and begin playing any
track.
2. Plug in earphones during MyFi broadcast and click fast forward one time to begin the
next.
3. Plug in earphones and click rewind one time.
4. During track playback, right-click the Joystick and select MyFi Mode. Right-click and
select Off.
5. During track playback, left click on the Joystick to return to the Neuros main menu.
In Settings, select MyFi and select Mode. Select Off.
14