H3C S12500G-EF Series Installation Manual page 96

3. Move the chassis so that the mounting holes on the horizontal ear of the L-type brackets align
with the mounting holes on the wooden pallet base. Use screws to attach the L-type brackets to
the wooden pallet base, as shown by callout 3 in
4. Cover the chassis with the packing bag from the top down, and then tape the bag to the plastic
cover of pallet base.
5. Erect one paper angle bead along each vertical edge of the chassis, and use the carton to
cover the chassis from top down with the mark side facing the front panel of the chassis
6. Cover the foam cushion to the chassis top, and make sure the mounting brackets seat into the
internal notches of the foam cushion. See callout 2 of
7. Put the box of packed accessories into the notch of the foam cushion that is near to the rear end
of the chassis, as shown in callout 3 of
8. Cover the top cap to the carton.
Figure 9-4 Attaching the L-type bracket to the pallet base (S12516G-EF)
(1) L-type bracket
(3) Use screws to attach the L-type brackets to the wooden pallet base
Figure 9-4.
Figure
Figure 9-5.
(2) Secure the L-type bracket to the chassis
9-5
9-5.