Mitsubishi Electric Mr. Slim PCH-GAK Installation Manual page 9

6. Electrical work
1
3
Fig. 6-
Function table
Select unit number 00
Mode
Power failure automatic recovery
Indoor temperature detecting
LOSSNAY connectivity
Power voltage
Select unit numbers 01 to 03 or all units (AL [wired remote controller]/07 [wireless remote controller])
Mode
Filter sign
Fan speed
No. of air outlets
Installed options (high-performance filter)
Up/down vane setting
Energy saving air flow (Heating mode)
*1 When the power supply returns, the air conditioner will start 3 minutes later.
2
4
Settings
Not available
Available
Main indoor unit
Main indoor unit
Remote controller's internal sensor
Not Supported
Supported (indoor unit is not equipped with outdoor-air intake)
Supported (indoor unit is equipped with outdoor-air intake)
240 V
220 V, 230 V
Settings
100Hr
2500Hr
No filter sign indicator
Standard (PLH/PL)/Silent (PCH/PC)
High ceiling 1 (PLH/PL)/Standard (PCH/PC)
High ceiling 2 (PLH/PL)/High ceiling (PCH/PC)
4 directions
3 directions
2 directions
Not supported
Supported
No vanes
Equipped with vanes (vanes angle setup 1)
Equipped with vanes (vanes angle setup 2)
Disabled
Enabled
) For wireless remote controller (Fig. 6-)
Changing the power voltage setting
• Be sure to change the power voltage setting depending on the voltage used.
1 Go to the function select mode
Press the button F twice continuously.
(Start this operation from the status of remote controller display turned off.)
is lighted and "00" blinks.
Press the temp button C once to set "50". Direct the wireless remote con-
troller toward the receiver of the indoor unit and press the
2 Setting the unit number
Press the temp button C and D to set the unit number "00". Direct the
wireless remote controller toward the receiver of the indoor unit and press the
button B .
3 Selecting a mode
Enter 04 to change the power voltage setting using the
tons. Direct the wireless remote controller toward the receiver of the indoor unit
and press the button A .
Current setting number: 1 = 1 beep (one second)
2 = 2 beeps (one second each)
3 = 3 beeps (one second each)
4 Selecting the setting number
Use the C and D buttons to change the power voltage setting to 01
(240 V). Direct the wireless remote controller toward the sensor of the indoor
unit and press the button A .
5 To select multiple functions continuously
Repeat steps 3 and 4 to change multiple function settings continuously.
6 Complete function selection
Direct the wireless remote controller toward the sensor of the indoor unit and
press the button E .
Note:
Whenever changes are made to the function settings after installation or
maintenance, be sure to record the changes with a mark in the "Setting" col-
umn of the Function table.
6.3.. Function setting on the remote controller
Refer to the indoor unit operation manual.
Mode no.
01
*1
02
03
04
Mode no.
07
08
09
10
11
12
button A .
C and
Setting no. Initial setting Setting
1
2
1
2
3
1
2
3
1
2
Setting no. Initial setting Setting
1
2
3
1
2
3
1 –
2 –
3 –
1
2
1
2
3
1
2
D but-