Table of Contents
Advertisement
Installing the stands
1
Remove the tape on the bottom of the TV set and the plastic
bag.
2
Fasten the stand to the TV with 2 screws. While fastening the
screws, hold the stand to prevent it from falling.
3
Both stands should now be securely fastened.
Note(s)
Make sure to use a table which can support the weight of this unit and is larger
●
than this unit.
Make sure the table is in a stable location.
●
A phillips-head screwdriver is required to fasten the stands to the TV set.
●
When attaching the stand, ensure that all screws are tightly fastened. If the
●
stand is not properly attached, it could cause the unit to fall, resulting in injuries
as well as damage to the unit.
To remove the stand from this unit, unscrew the phillips-head screws by
●
reversing the procedure. Be careful not to drop the stand when you remove it.
Lifting the TV set
Carefully lift the TV set as shown in the illustration and place it onto
a stable, level surface.
Installing the remote control batteries
1
Slide the battery cover off the back of the remote control.
2
Insert two batteries (AAA, 1.5V). Be sure the + and – ends of the
batteries line up with the markings inside the case.
3
Slide the cover back into position.
Note(s)
Remove the batteries if not using the remote control for an extended period of
●
time.
8
.
English
Continued on next page.
Advertisement
Table of Contents
