Sanyo FW43C47F Owner's Manual page 40

Wireless network setting
This menu is displayed only when you set Wireless in Network
selection. In order to use a wireless network, you must set up a
connection to the AP (e.g. wireless router).
2
Use H I to select Wireless network setting, then press OK.
Auto
Search for wireless networks automatically and select the SSID from the
list.
3
Use H I to select Auto, then press OK.
4
The list of wireless networks will be displayed. Use H I to select
the appropriate the SSID, then press OK.
Auto Router 1
Manually enter your SSID Router 2
Router 3
Router 4
If you select the SSID with
●
will appear. Enter the WEP
network using H I J K, then press OK.
If you select the SSID has an easy connect, the easy connect
●
setting screen will appear. Use H I J K to select a setting, then
press OK.
Select this setting if your router has an easy
connect button. Start scanning for wireless
networks on the TV after pressing the easy
Simple Connect
connect button on your router. If connection test
fails, try Simple Connect again.
refer to the router's manual for more details.
Select this setting if your router has an easy
connect feature but does not have an easy
Pin code connect button. Enter the 8-digit PIN code shown
on your TV in the Router settings menu via PC
before Connect is selected.
If your wireless network with authentication
setting (WEP
screen will appear. Enter the WEP
Manual
of the selected wireless network using H I J K,
then press OK.
Simple Connect cannot be used when the security protocol is set
*1
to WEP. Change the Access Point's security mode from WEP to
others (recommended).
WEP is not recommended to be used due to its major security
*2
flaws. Change the security protocol on the wireless router to others
(recommended) mode.
Confirmation message will appear. Select OK to complete the settings.
Note(s)
For a wireless network with authentication setting, key icon appears to the right hand of the
●
SSID.
Signal icon shows the strength of the signal.
●
WEP / others key appears as asterisks on the confirmation screen.
● *2
The wireless LAN supports following specifications.
●
Wireless standards: IEEE 802.11 b/g/n
–
Frequency spectrum: 2.4GHz
–
Security protocol: WEP / others
*2
–
Simple Connect
Pin code
Manual
, WEP / others Key entry screen
*2
/ others key of the selected wireless
*2
If it fails then
*1
, others), WEP / others Key entry
*2 *2
/ others key
*2
Manually enter your SSID
Set up the connection to the AP (e.g. wireless router) manually by
entering the SSID.
3
Use H I to select Manually enter your SSID, then press OK.
AP (e.g. wireless router) SSID entry screen will appear.
●
Enter the SSID using H I J K, then press OK.
4
Use H I to select the authentication setting of the selected wireless
network.
For a wireless network with authentication setting, select the
●
authentication setting, according to the security type of the
wireless network.
Auto XXXXXXXXXXXXXX
Manually enter your SSID
None Set the authentication setting to None.
WEP Set the authentication setting to WEP
Others Set the authentication setting to Others.
For a wireless network without authentication setting, select None.
●
If you select WEP or Others, WEP
● *
appear. Enter the WEP / others key of the selected wireless network
*
using H I J K, then press OK.
Confirmation message will appear. Select Yes to complete the
●
settings.
* WEP is not recommended to be used due to its major security flaws.
Change the security protocol on the wireless router to others
(recommended) mode.
40
None
WEP
Others
.
*
/ others Key entry screen will
*
Continued on next page.
.
English